MIL-DTL-6363/6A
NOTES:
1.
Dimensions are in inches.
2.
Intended use - aircraft instrument, and panel light assemblies.
3.
For design feature purposes, this specification takes precedence over procurement
documents referenced herein.
4.
Qualification by similarity - Lamp M6363/6-5AS15 is required to be fully qualified in
accordance with table I of MIL-DTL-6363. Lamp M6363/6-4AS15 is required to be
qualified in accordance with table II of MIL-DTL-6363. All other basic lamps
(MSCD ±25 percent) and "AS" designated lamps may be granted qualification by
similarity and extension of qualification from the qualified lamps with no additional testing.
Refer to MIL-DTD-6363 for conditions and data required for qualification.
REQUIREMENTS:
1.
Configuration and dimensions: See figure 1.
2.
Construction:
a.
Standard lamp construction shall include a side weld or solder bead and solder bead
bottom contact.
b. Where required for greater reliability and added resistance to corrosion and internal
shorting, solderless construction is available as an option by the addition of a dash and
suffix letter "S" to the part identification number in table I.
EXAMPLE: M6363/6-1-S
When specified, solderless construction shall include a side weld and nickel plated brass
bottom contact.
c.
Insulator shall be color coded as follows to identify voltage rating of lamps:
5.0v - Green
28.0v - Red
3.
Finish: Glass globe finish shall be as indicated in table I.
4.
Lamp operating characteristics: When operating at rated voltage, the lamp operating
characteristics shall be as specified in table I.
5.
Where indicated by suffix "AS15" in the part number, lamps shall be aged for a minimum
of ten hours at rated voltage and selected for 15 percent tolerance on MSCD as indicated
in table I.
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business